Edson Powerboat Products Virtual eCatalog: Page 16

TILLER ARM ORDERING GUIDE - Tiller Arms must be positively secured on the rudderpost in addition to the tight clamping tolerance. This can be done by: 1) Securing the Tiller Arm to a solid rudderpost stock by cutting a keyway in the rudderpost and in the Tiller Arm. 2) Through-pinning the Tiller Arm to a hollow rudderpost. Edson will provide a predrilled Tiller Arm cap and a 3/8"/1.3 cm stainless pin. 3) Securing with set screws by drilling and tapping into the quadrant cap and the rudderpost (be it solid or hollow). Please specify the method of securing when ordering. NOTE When Ordering Tiller Arm Specify: · Rudderpost diameter specified to 3 decimal places (2.376"). Specify method used to secure Tiller Arm to rudderpost. See Tech Tip for details. For additional information request Engineering Bulletin EB-373-97. Edson's Bronze Clevises - Commonly used in hydraulic and push-pull steering and autopilot systems. Constructed of manganese bronze. Available in three sizes. Bore is fully threaded. Additional thread sizes available on special order. Depth of jaw is 23/16"/5.56 cm from pin center. Order #619 (See Ordering Guide for sizes) Note: Other thread sizes available on special order. Edson's Drag Links make twin rudder installations easy. Each Drag Link is manufactured from the highest quality materials. Stainless steel bar stock is used for its superior strength and corrosion resistance and the Clevises are made of manganese bronze to fit virtually any tiller arm. Choose from Edson's standard configurations or provide us with your specifications and we will build what you need.