Edson Pumps
Edson Marine Marine Store
Marine Store

In-Out Conduit Idler - 6" w/ Needle Bearing


Item Number: 962-6ALNB

Edson’s In-Out Conduit Idler is designed to increase the efficiency and sensitivity of a Pull-Pull Conduit System. Engineered with 6” sheaves and three holes to accept Edson’s Conduit End Fittings, the idler makes wire alignment with the sheave automatic. It is recommended that these idlers be used at major load points in engine compartments to allow the steering cable to run over a sheave when being routed aft. Required on center cockpit pull-pull systems over 39’ (12 m).

Add to Cart:

  • Item Number: 962-6ALNB

Copyright © 2012 The Edson Corp.
FedEx service marks used by permission.
Accept Credit Cards